How to make a manual planter for carrots with your own hands

the main » Garden » Carrot

Planting carrots always takes time. If you sow the seedlings in random order, then they will have to be thinned and removed weak sprouts as they germinate. To reduce time for landing, and also to land evenly use seeders. They can be purchased or made independently.

Types and advantages of using a seeder for carrots

The seeders made for manual crops are divided into several types:

1. Tuk - recommended to simplify the process of fertilizing or distributing lime over the territory;
2. Gardening - designed for sowing seeds of agricultural needs in areas near the house or vegetable gardens;
3. Cereal-cereals - provide for planting on vast territories - on grain fields.

A simple planter can be made from the improvised material, especially without spending money. But all simple devices are made only under the hole, that is, it is often problematic or almost impossible to adjust the required volume of the hole.

The advantages of this device are:

• Uniform seeding planting material;
• Placing on the same the depth;
• The same distance between plantings;
• Simplicity in use;
• Ease in building.

With this unit, you can quickly and in a short time to land a vast territory. After working with a seeder for carrots do not have to pull out the extra seedlings, injuring those that remain for further growth.

Manual seed planter

This type of technology is used for planting over vast areas. It is able to create even grooves, in them impose a uniform number of seeds. It can be used not only for sowing planting material of carrots, but also for beets, onions, parsley, lettuce or other small seeds.

The groove is made by moving the wheel on which special blades or spikes are located. With these growths, the wheel creates wells of a certain size with the same depth.

The device of the seeder is such that a spout from the bunker goes through which a certain amount of seeds is sown. The flow of seedlings is strictly regulated by a special valve.

Behind additionally there is a wheel with a smooth surface, which during movement falls asleep and tamps holes with planting material.

Piston

Piston planter for carrots looks like a plastic container, cylindrical character. The landing material is located in it.At the bottom there is an adjustable cone opening for sowing seedlings into soil. On top of this device is a piston equipped with a spring.

This unit works on the principle of extruding a certain amount into a previously prepared recess in the ground. So that the seedlings do not fly apart in different directions, the piston seeder is placed 5 cm above the ground level.

Some farmers consider a piston planter a problematic device, while replacing it with an ordinary medical syringe. But working with a syringe gives a lot of inconvenience:

1. When squeezing the seeds, they often fly apart;
2. Pressing the syringe cannot be controlled, therefore, the seeds are poured out in a different volume.

Piston landing system is designed for large areas, and with a syringe do not infuse a lot. Therefore it is better to use a piston with a springy pressing.

Funnel

One of the simplest mechanisms is a large dispenser with a miniature “spout”. A cone extending into the ground has a hole, the volume of which can be adjusted by the diaphragm inside.

The funnel is installed above the ground at a height of up to 15 see and gently shake the drug. Seeds, rolling out along the groove, evenly fit into the furrow.

Using such a funnel-bowl it is possible to achieve correct, even grooves, while not thickened with an excessive amount of seeds.

The disadvantage is the need to adapt or adapt to such work.. If you shake it often or strongly, you can plant the seeds not at all in the groove, but around the whole area.

Sazhalka for carrots from bar

This method of planting resembles the method of planting using a tray from under the eggs. For the production of planters from the bar will require several plastic caps and a wooden bar. Its dimensions can be arbitrary, but it is better to adhere to the verified volume of wooden wooden - 5x5x50 cm.

Covers are nailed on one of the sides. It is required to loosen the ground well so that it is airy and soft. The topsoil is leveled evenly. Side with covers lowered into the soil and pressed. After the bar is raised above the surface, even holes in the soil substrate remain for planting carrot seeds.It remains only to put the prepared seedlings and sprinkle.

Mini rake for planting seeds

A rake for landing is easy to perform if you have previously had experience with a hacksaw or a jigsaw. For the prepared beds should pick a long board, such that it completely covers the area.

Also for the production of rakes will need a tree bar, up to 20 cm - it will be a handle.

The lower side (end) to be cut. Peculiar teeth in the form of a trapezium are cut out on it, so that the lower base is no more than 1 cm, and the depth reaches 2 cm. On the flat side, place the handle on the center. This can be done with a nail. Work on the mini-rake is over.

To perform the sowing, it is required to lower the improvised rake on the dug up, airy section and run along the perimeter. On the site in an instant smooth grooves are formed, in which it is required to lay planting material.

Additional types of seeders

There are many methods for planting seeds.Seedlings of carrots represent the greatest difficulty for gardeners. They are quite small and difficult to plant evenly. After germination, a very large number of young shoots must be removed. Therefore, it is recommended to use different methods for planting:

1. Sowing using toilet paper - on the cut of toilet paper in random or strictly defined order glued numerous seeds. Later this site is covered with a small layer of earth. When sprouts sprout, they do not need to be discharged. Only, among them weeds sprout abundantly. The disadvantage of the method is the long-term gluing of small seedlings on a piece of paper;
2. Seeder from egg container - original and easy way. The advantages of the method is the simplicity and evenly planted seeds at the required distance. To do this, press the tray into the ground and pour planting material of 1 or 2 seeds into the resulting holes;
3. Using tape - in specialized stores you can find a special ribbon for planting carrots. Seedlings are already glued to it in the required order and at the optimal distance.Landing is easy to perform - a tape is applied on the furrow made and powdered with earth.

Thus, in order to plant carrots without a seeder at home, you can easily, but before that you need to spend either money or be patient, laying small seeds on toilet paper. But to get a rich, and most importantly, even harvest, you can make any sacrifice.

How to make a manual planter for carrots with your own hands?

In the case when there is no excess financial resources for the purchase of a seed drill, it can be done personally. Before work, you should make a drawing and an individual design of the future unit. It is best to do everything with simple models.

For the production of the necessary axis, aluminum tubes, and wheels, as well as iron, sheet format. From these parts you can make an excellent home-made planter without resorting to heavy and expensive technologies.

Collection scheme:

1. Aluminum tubes are turned into handles. It requires to measure the angle of inclination and adjust the height of the planter to grow; it is best to design the handles “away from you”;
2. Bunkers for seeds are formed from iron in the form of cones or funnels. They are located on the axis in such a way that between them there is a small space of 1 cm;
3. Each the funnel should go down with a sharp cone, inside of which there is a hole 0.1 cm wide;
4. The central axis connects to the wheels., bunkers are placed on top of the axis to which the handles are attached;
5. Additionally, you can optionally install row limiter.

Thus, using seed drills, you can not only plant seeds in your garden or cottage with pleasure, but also spend less time. Besides, when working with technologies of similar planting it is not necessary to remove excess sprouts as the culture grows. If you follow the recommendations, you can make your own high-quality equipment and plant large areas, not only carrots, but also other crops.